Tel : 0086-0371-86172891
Originally used in shopping malls, supermarkets, and hotels, freezer is popular in households now. It is used in a gentle environments and has similar structure as refrigerator. The trend is to use thinner sheet with high strength.
1. Case Side Plate
Part requirements: Proper stiffness, movable; Flat and straight; Proper hardness and no deformation after foaming.
Material Requirements: Flat and Straight; Thickness≥0.35mm; Hardness HRB≥40
Recommended materials:
Part No. |
Part No. |
Type |
Grade |
Size(mm) |
Specialty |
1 |
Case Side Plate |
General cold rolled steel |
BLC-JD2 |
0.4-0.5 |
Spray painting after parkerizing |
Prepainted Steel |
TSECD |
0.4-0.5 |
Oil-resistant coating; |
||
TDX52+Z |
2. Door panel
Part requirements: Flat and straight; Proper hardness and no deformation after foaming.
Material Requirements: Flat and straight; Hardness HRB≥40
Recommended materials:
Part No. |
Part No. |
Type |
Grade |
Size(mm) |
Specialty |
2 |
Door Panel |
General cold rolled steel |
BLC-JD2 |
0.4-0.5 |
Spray painting after parkerizing |
Door panel |
TSECD |
0.4-0.5 |
Oil-resistant coating; |
||
TDX52+Z |
3. Hinge Plate
Part requirements: Proper strength and stiffness; No deformation when bearing weight.
Material Requirements: Flat ; Y.S ≥300MPa.
Recommended materials:
Part No. |
Part No. |
Type |
Grade |
Size(mm) |
Specialty |
3 |
Hinge Plate |
General cold rolled steel |
2.0 |
Spray painting after parkerizing |
4. Case Back Plate
Part requirements: Flat and Straight, no exceptional requirement.
Material Requirements: Flat and straight; Easy for assembly.
Recommended materials:
Part No. |
Part No. |
Type |
Grade |
Size(mm) |
Specialty |
4 |
Case Back Plate |
General cold rolled steel |
BLC-JD2 |
0.4-0.5 |
Spray painting after parkerizing |
Door panel |
TSECD |
0.4-0.5 |
Oil-resistant coating; |
||
TDX52+Z |
5. Base Plate
Part requirements: Work well in moist environment.
Material Requirements: Corrosion-resistance;Good forming performance.
Recommended materials:
Part No. |
Part No. |
Type |
Grade |
Size(mm) |
Specialty |
3 |
Base Plate |
General cold rolled steel |
1.5 |
Spray painting after parkerizing |
6. Compressor Motor
Part requirements:Low noise level;Smaller; Energy-efficient;
Material requirements: Small thickness tolerance; high magnetic induction; Low iron loss;Flatness
Recommended materials:
Part No. |
Part No. |
Type |
Grade |
Size(mm) |
Specialty |
6 |
Compressor Motor |
Electrical steel |
B50AE-3 |
0.5 |
High-efficiency |
environmental friendly |
|||||
7. Compressor Case
Part requirements: Improved welding and coating property;Pressure-resistant
Material requirements: Deep drawing quality; Uniform performance.
Recommended materials:
Part No. |
Part No. |
Type |
Grade |
Size(mm) |
7 |
Compressor Case |
Pickled steel |
2.6-4 |